Fluval FX5 disconnect issue
3 posters
:: Freshwater :: Freshwater General
Page 1 of 1
Fluval FX5 disconnect issue
I went to disconnect the hoses so that I could clean the foams, but cannot get the quick connect to release on the intake. Output came off fine though. Even used a small screwdriver to add a bit of pressure but still no go.
Any ideas?
Any ideas?
Sandman1969- Angel Fish
- Posts : 398
Join date : 2013-09-15
Re: Fluval FX5 disconnect issue
The manual I found online said they just are push on and pull off if I read it right so maybe try a little harder with the screwdriver or try a little larger one.
Good luck.
Or just remove the top and leave the connector alone.
Good luck.
Or just remove the top and leave the connector alone.
Fores41- Pleco Poster
- Posts : 829
Join date : 2013-09-17
Location : Williams Lake,BC
Re: Fluval FX5 disconnect issue
Ya, it normally does just release & lift up. But for the life of me, the one will not come off now. The canister is under the tank so there's no room to lift off the top where it sits.
Sandman1969- Angel Fish
- Posts : 398
Join date : 2013-09-15
Re: Fluval FX5 disconnect issue
There is no latch or locking mechanism, so it cant possibly be permanently stuck in place. What holds them tight are just the rubber gaskets. I'm sure you are aware of the release button on the side of the valve? It helps but is not really necessary to remove the valves. If the valve will turn, it will come off. I would be hesitant to pry with a screwdriver. Any nick, dent etc in the wrong spot may cause permanent damage. Twist turn wiggle pull up, it has to come off
Suprd71- Angel Fish
- Posts : 296
Join date : 2013-09-08
Location : North Bay On.
Re: Fluval FX5 disconnect issue
Because of where the canister sits, the valves must come off. Yes, I know about the release button as I mentioned I tried using a small screwdriver on it.
I eventually got it off & noticed the O ring was out of shape which may have prevented removal prior and also caused a leak til I found a replacement.
I eventually got it off & noticed the O ring was out of shape which may have prevented removal prior and also caused a leak til I found a replacement.
Sandman1969- Angel Fish
- Posts : 398
Join date : 2013-09-15

» Fluval C4 trickle flow issue
» Just got a Fluval FX5....
» PLECO issue
» Fluval FX5 questions
» Aquaclear 500 issue
» Just got a Fluval FX5....
» PLECO issue
» Fluval FX5 questions
» Aquaclear 500 issue
:: Freshwater :: Freshwater General
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
» Anyone still around? Need help transporting fish
» Stocking suggestions
» New Tank Purchase
» 3 Gallon Tetra half moon tank
» White floaty stuff in gold fish tank
» Ammonia in tap water
» Need advice for beginner with fresh water tank
» Fluval FX5 hose size?
» smart fish, dumb fish, pink fish...um, what rhymes with dumb?
» Is K&E sandblasting sand same as Black diamond?
» What the...is that a leak? NOOOOOOOOOOO!!!!! (a comedy of horrors...)
» Air stones and the noise they make
» aquatic medications
» film like stuff on the water surface of shark tank
» Articles on swordtail behaviour and fathead minnows
» Lets see your predators!
» Humane way to PTS a shark
» My tanks (Introducing myself)
» Build your own aquarium