How to replace a starter?

by **Biulu** Mon Nov 04, 2013 4:06 pm

I have a hood with a strip light for a 20 gallon long and the light was not longer working, so I replaced the tube. Turns out that the light is still not working, so I bought new starters.

I unscrewed the 2 little screws but am not able to open up to get to the starter. Does anybody have an idea of how to do this?

by sucker4plecos Mon Nov 04, 2013 4:10 pm

It depends on how the start is put in .... many models the started looks like a fuse and it has two pins that are slotted in and twisted..... to remove you simply twist and pull it out......

by **Biulu** Mon Nov 04, 2013 4:40 pm

This problem has resolved itself in the sense that this strip light is that old that it doesn't have the 2 pin fuse.

It has a rectangular box that I think serves as a starter, but I have no clue how to remove it, or to replace it, so I guess this means buying a new strip light.

S4P: the problem was getting to open up the light to access the starter. In the end I broke off a few plastic holders to get access to the inside...

by sucker4plecos Mon Nov 04, 2013 4:51 pm

Always good to have an excuse (as if we need it) to buy some new equipment.......

by **Sbenson11** Mon Nov 04, 2013 5:54 pm

Though I was in the car forum there for a minute.

That's pretty week though just the same, you just wanted a new light anyway. Smile

Steve

1	#2
2	#highlightplants
3	#mediumlightplants
4	#1
5	#lowlightplants
6	#canadaquaria
7	#moderators
8	#livebearers
9	#3

Mon	Tue	Wed	Thu	Fri	Sat	Sun
	1	2	3	4	5	6
7	8	9	10	11	12	13
14	15	16	17	18	19	20
21	22	23	24	25	26	27
28	29	30	31

How to replace a starter?

How to replace a starter?

Re: How to replace a starter?

Re: How to replace a starter?

Re: How to replace a starter?

Re: How to replace a starter?